Mega Press is suitable for mass production. This machine is equipped with many advanced features. While designing major areas like operator safety, easy to operate and clean, minimum change over time for tool and product are taken into consideration.

INNOVATIVE FEATURES

• Front and easy outside controls.
• Turret made of highly ductile SG iron casting.
• Detachable control panel - safe against electric short circuit during steam wash.
• Discharge chute with auto rejection deflector.
• Electro magnetic clutch.
• Inter locking guards.
• Gas assisted starts.
• Bigger capacity hopper.
• Lower Punch Seals.

EJECTION CHUTE

A Tablet ejection chute is fitted as standard inbuilt feature to all 'Mega Press'. It is controlled by a preset timer, the ejection chute will automatically rejects all "start up" and "run down" tablets.

QUICK & EASY TOOL CHANGE OVER

'Mega Press' has been designed to minimize the change over time. The weight adjustment section is easily removable which provides good access for the removal/replacement of lower punches and dies. This adjustment can be done without opening lower cabinet, away from compression zone. The handwheel is conveniently located for indexing the turret during tool changeover with single operator.

PRODUCT CHANGE OVER

The powder loss and downtime is reduced substantially as feeders are fitted with powder discharge chutes. This Chute when used with hopper cut off slides, allows the feeder to be emptied before removal. Easy access to upper Punch for removal due to quick release mechanism. Also this helps in weight adjustment section for easy access to lower punches. More room for cleaning at bottom is provided as there is no corner pillar. The feeder drive and control mechanisms are sited below the tabletting zone, father reducing cleaning time and eliminating the possibility of product cross contamination. The upper punches are protected form dust by an upper punch guard.

This helps in the minimizing the possibility of tight upper punches and reduces, punch head and cam wear. Upper punch penetration adjustment also can be done from outside the compression zone.

Hoppers, doors and guards of lower cabinets etc. are quick removable without using any tools. This also helps in reducing downtime.

EXTRA FEATURES ON DEMAND

• AC inverter Variable drive for main and feeder motor.
• Auto lubrication with fine tuning valve and timer.
• Polo type tablets/core rod Punches & Dies fittings for 37 & 45 stn. only
• Hopper granules level sensor
• 3 - Pc - Turret with S.S. 316 Die Pot
• Pre-Compression.
• PLC Control
• Hydraulic Power Pack.
• Effervescent System.
• Upper Punch Cap Seal.